Post by quietman on Nov 20, 2021 23:34:23 GMT
Have the Lionmaster Challenger with Legacy / TMCC. Don't have a Legacy command base.
Trying to lower the smoke as it's too much for my wife if I run it under the tree. (run the MTH locos on low under the tree). Have followed the instructions on page 21 of the challenger manual, but no change seen. Does this have to be in program mode, or do you need to hit the set key, but they left that out?
Also can't get the address to change either when using the TMCC remote.
All running functions are working. Bell , whistle, crew talk, etc
Trying to lower the smoke as it's too much for my wife if I run it under the tree. (run the MTH locos on low under the tree). Have followed the instructions on page 21 of the challenger manual, but no change seen. Does this have to be in program mode, or do you need to hit the set key, but they left that out?
Also can't get the address to change either when using the TMCC remote.
All running functions are working. Bell , whistle, crew talk, etc
