Post by JKP on Sept 15, 2021 23:59:53 GMT
I had a communication issue with one of my SD70s tonight, wasn't picking up the signal. It kept running like it was in conventional mode whenever I turned the throttle up even though the legacy command was on (I use a Z4000). I took the top off and put it in program mode, same thing started going when I applied the throttle. Then I turned the throttle down again, held the set button on the legacy controller with the program switch on still in the engine and pulled the throttle up again to give it power- the horn sounded-all is good now. Don't know why it wasn't picking up the signal.
