Post by dctrainguy on Jun 4, 2024 2:15:39 GMT
Hi all, I just recently upgraded some old proto 1 engines to proto 3. I just bought a brand new DCS explorer to run them. Figured I purchase the DCS till whenever in the future the new WIU comes out.
My layout has 2 tracks. I’m powering up the DCS with my Z400 on the 14V ports in back of it. I get power to the DCS, get the MTH WiFi connected to my IPad but the red light for track does not come up on the DCS.
I connected the track power to only 1 track on the DCS. The ground I spliced to all my other grounds including going to track 2.
When I try to connect the engine it says no engine found. Is there something I’m doing wrong? Any input would be greatly appreciated.
My layout has 2 tracks. I’m powering up the DCS with my Z400 on the 14V ports in back of it. I get power to the DCS, get the MTH WiFi connected to my IPad but the red light for track does not come up on the DCS.
I connected the track power to only 1 track on the DCS. The ground I spliced to all my other grounds including going to track 2.
When I try to connect the engine it says no engine found. Is there something I’m doing wrong? Any input would be greatly appreciated.
